Shop

Hard polyurethane lacquer for elementary and protective coating. Isocianathaltig - 70.00 €

High-quality polyurethane dilution - 120.00 €

Glass Primer 1 Litre - 90.00 €

Glass surface pretreatment by primer
To achieve optimum adhesion results of the primer coatings on glass is used. By simply applying a thin transparent intermediate layer is produced, on the one hand, reacts chemically with the glass and on the other hand, with the later applied paint. The consequence is an intense bond between glass and paint.

Wide applicability
The primer can be used on all glass surfaces. Can also be enameled or glazed surfaces are primed.
In each case, however, should be about in their own experiments shall examine the applicability.

Application friendly
The primer used is supplied and should not be diluted. The primer applied by wiping or spraying. After a short drying period (approx.10-20 minutes) can be made directly to paint. Primed surfacess hould be painted over within a few hours so the effect of humidityis not reduced unnecessarily.

Economic Use
The primer should be applied only in small amounts of 30-50g per qm are sufficient.

Special Notes
If too much primer is applied, then this may result in whitish streaks, which disturb the subsequent paint finish.

80.00 €

ChromoDur Stain 1 Litre 

Two components ChromoDur glaze is suitable for the nuances of the metallization. 

Substrate materials: metallization

Applications
Metallization of metals and plastics 

Preparation
The surface to be painted must be completely clean and free of grease, oil, dust and other contaminants. 

Processing information
Before processing, are mixed: 

ChromoDur glaze

100 parts by weight ChromoDur glaze 
15 parts by weight ChromoDur Harter 

With the limited storage stability ChromoDur Harter is to be observed by 4 months in original sealed container. 
Protective coatings must not be burnt as the base coat (min. 20 ° C temperature difference) at higher temperatures. 
After applying the glaze ChromoDur recommend a UV protective varnish (ChromoDur plus) to add transitions in two spray. 

Physical properties
Pot life: about 4 hours (temperature independent) 
Delivery viscosity: 28s + / - 3s / 4 mm DIN (20 ° C) 
Of thinning: 25-35% ChromoDur-dilution 
Spray Viscosity: 15-20s / DIN 4mm (20 ° C) 
Nozzles diameter: 0.8-1.0 mm 
Air pressure: 2-3 bar 
Exhaust: 5 - 10 min 
Drying temperature: 50 ° C 
40 ° C - 60 ° C varnish 
Drying time: 80 min. or overnight drying at 20 C. 

The technical advice, technical advice and other information are based on current knowledge. They are not binding and without any liability. You do not absolve the user from their own tests!